ECT 125 Week 3 iLab 1 Amplitude and Time Latest
ECT 125 Week 3 iLab 1 Amplitude and Time New
iLab Steps
Part I: Amplitude Measurement
1.Construct the circuit shown below on your breadboard.
2.Set the function generation to provide a 0.25 V RMS amplitude sine wave. Measure the amplitude of the wave with the DMM and oscilloscope. Record your measurements in Table 1.0
3.Repeat your measurements for each of the amplitudes on the function generator.
4.Return the amplitude back to 1 VRMS and change the frequency of the function generator to 5 kHz and measure the voltage with the DMM and oscilloscope.