ECT 125 Week 3 iLab 2 Inductor Phase Shift Latest

ECT 125 Week 3 iLab 2 Inductor Phase Shift New

Inductor Phase Shift

iLab Steps

Part I: Phase Shift Measurement

1.Construct the circuit shown below on your breadboard.

2.Set the function generation to provide a 1 V_RMS amplitude sine wave at 500 Hz. Measure the inductor voltage and the phase shift between the source and inductor voltage.

Part II: Time and Voltage Measurement

1.Construct the circuit shown below on your breadboard.

2.Set the function generation to provide a 1 V_RMS amplitude sine wave at 200 Hz. Measure the inductor voltage and the phase shift between the source and inductor voltage. Note whether the phase shift is ahead of or behind the source.